10-6
Remote Operations
Model 6220/6221 Reference Manual
Return to
See
“Ethernet interface reference,” on page 10-29
for more information on the
Ethernet interface.
Password
A user-defined password can be used to disable protected commands. Most
Model 622x commands are protected (see
for a list of unprotected
commands). When the use of password is enabled, there are commands to either
disable or enable the protected commands (
).
At the factory, the Model 622x is assigned the following password name:
“DEFAULT”
The password is case sensitive and must be enclosed in quotes, as shown above.
From the front panel, the password can be cleared by using the PASSWORD
selection in the communications menu (see
) as follows:
1.
Press the COMM key, select PASSWORD, and press ENTER.
2.
To clear the password, select YES, then press ENTER. The “PASSWORD
CLEARED” message will be displayed.
Remote interface configuration commands
Commands to select the GPIB, RS-232, and Model 6221 Ethernet interface, to
control the password, and to configure the RS-232 and Ethernet interfaces by
remote are listed in
. Additional information for each command is pro-
vided in notes that follow the table. See
“RS-232 interface reference,” on
for more RS-232 information, and
“Ethernet interface reference,” on
for more Ethernet information.
NOTE
When the IP address, the Ethernet gateway, or
subnet mask is changed, the unit will perform a
power-on reset when leaving the menu.
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176 - TestEquipmentDepot.com
Summary of Contents for 6220
Page 16: ...Test Equipment Depot 800 517 8431 99 Washington Street Melrose MA 02176 TestEquipmentDepot com...
Page 24: ...Test Equipment Depot 800 517 8431 99 Washington Street Melrose MA 02176 TestEquipmentDepot com...
Page 453: ...Test Equipment Depot 800 517 8431 99 Washington Street Melrose MA 02176 TestEquipmentDepot com...
