Keba D3DP 3 Series, Project Engineering Manual, Page: 23 / 82

D3­DP 3xx/x Mounting and installation instructions
Project engineering manual V1.00
23
© KEBA
5 Mounting and installation instructions
During the installation it is imperative to avoid
● Drill chippings, screws or foreign bodies dropping into the device
● Moisture entering the device
WARNING!
Dangerous voltage may be applied to the device, even if the device does
not emit any visual or audible signals/indications!
Caution
Installation must only be carried out by qualified electricians who have un­
dergone instruction in the necessary accident prevention measures.
Caution
Electric drives are dangerous:
● Electrical voltages 230 / 400 / 480 V AC or 325 / 565 / 678 V DC
● Dangerously high voltages ≥ 50 V (capacitor charge) may still be present
3 minutes after the power is cut. So check that electrical power is not
present!
● Pay attention to warning sign on the device (see front of device).
Information
For installing the supply module within a system, also note the project man­
uals of the control module and the axis module.
Control cabinet
● The devices are solely intended for installation in a stationary cabinet.
The cabinet must as a minimum provide IP44 protection. According to
EN ISO 13849­2 the cabinet must have degree of protection IP54 or
higher on using the safety functions in the axis module or a D3­DU 3x5/
x.
Environment
● The axis modules must not be installed in areas where they are exposed
to continuous vibration. (See
12.1 Ambient conditions ).
Pollution
● Max. pollution severity 2 to EN 60664­1. (See 12.1 Ambient conditions ).