Kärcher KM 100 R D, User Manual

Page: 19 / 364

-
4

DANGER
Risk of injury and damage! Do not use a
forklift to unload the appliance.
To unload the machine, proceed as follows:
 Cut plastic packing belt and remove foil.
 Remove the elastic tape fasteners at
the stop points.
 Four indicated floor boards of the pallet
are fastened with screws. Unscrew
these boards.
 Place the boards on the edge of the pal-
let. Place the boards in such a way that
they lie in front of the four wheels of the
machine. Fasten the boards with
screws.
 Slide the four support beams included
in the packaging under the ramp.
 Remove the wooden blocks used for ar-
resting the wheels and slide them under
the ramp.

Danger
Risk of injury! Before engaging the free-
wheel operation, the machine must be se-
cured to prevent it rolling away.
NOTICE
Do not move the machine for long distanc-
es without engaging self-propulsion, a
speed of 6 km/h should not be exceeded.
1 Position of the freewheel lever up - ap-
pliance can be pushed.
 Opening and securing cover
 Engage the freewheel lever in the upper
position.
This blocks the travel drive function.
 Close cover.
The machine can now be pushed.
1 Position freewheel lever down - appli-
ance is ready to start.

Engage the freewheel lever in the lower
position.

Close cover.
The appliance can now be driven.
 Park the sweeper on an even surface.
 Remove the key.

Danger
Risk of explosion!
–
Only use the fuels specified in the Op-
erations Manual.
–
Do not refuel the machine in enclosed
spaces.
–
Smoking and naked flames are strictly
prohibited.
–
Ensure that no fuel reaches the hot
open surfaces.
 Switch off engine.
 Opening and securing cover
 Check fuel level via the tank indicator.
 Open fuel filler cap.
 Fill in diesel.
 Fill tank to max. 1 cm below the lower
edge of the filler nozzle.
 Wipe off any spilt fuel, remove funnel
and close fuel filler cap.
 Close cover.
 Open the hood, insert retaining rod.
 Release the wing nuts from the seat
rails.
 Slide the seat into the desired position.
 Tighten the wing nuts.
Note: If this adjustment is not enough, it
can be adjusted more.
 Remove 4 screws on the plate of the
seat contact switch.
 Remove the plate.
 Swivel the seat to the front.
 Loosen 4 screws on the seat support.
 Slide the seat and tighten the screws.
 Install the plate of the seat contact
switch.
Before Startup
Unloading
Moving sweeper without engaging
self-propulsion
Moving sweeper by engaging self-
propulsion
Start up
General notes
Refuelling
Refuelling the machine
Operation
Adjusting driver's seat
19 EN