4
English
5.906-736.0 Rev. 00 (07/15)
10.10 Water connection
93
10.10.1 Operation with external water supply
93
10.10.2 Operation with water from the water tanks
94
10.11 Refill fuel
94
10.12 Refill detergent
94
10.13 Refill liquid softener
94
11 Basic settings and service procedures
95
11.1 Axle
/
drawbar
95
11.1.1 Lubricate the brake on the drawbar
95
11.1.2 Lubricating the crank drive of the support wheel
95
11.1.3 Replacing wheel
95
9.4 Lights
45
11.2.1 Front light - replacing the lamps
96
11.2.2 Rear light - replacing the lamps
96
9.5 Covers
47
11.3.1 Replace the gas pressure damper
97
11.3.2 Dismantling covers
99
9.8 Battery
/
inverter
49
11.4.1 Charge / replace battery / check fluid level
100
11.4.2 Replace the inverter
102
11.5 Water
inlet
102
11.5.1 Lubricating the rotating grommet low-pressure hose reel
102
11.5.2 Clean water filter.
102
11.6 Liquid
softener
103
11.6.1 Cleaning the level switch
103
11.6.2 Exchanging the level switch / dosing valve
103
11.7 Swimmer
tank
105
11.7.1 Exchanging float valves
105
11.7.2 Exchanging the level switch / temperature sensor
107
11.8 Heat exchanger (16kW)
108
11.8.1 Replacing the heat exchanger
108
11.8.2 Clean heat exchanger
109
11.9 High-pressure
pump
109
11.9.1 Check oil level and refill oil
110
11.9.2 Oil change in high pressure pump
111
11.9.3 Cleaning the fine filter
112
11.9.4 Check and adjust the speed control full load / idle mode
114
11.9.5 Replacing wear parts of the overflow device
115
11.9.6 Changing the valve frost protection
117
11.9.7 Changing the pressure switch
118
11.9.8 Replace the suction valves.
119
11.9.9 Replace pressure valves
122
11.9.10 Replace the overflow valve
124
11.9.11 Cylinder head, uninstall
125
11.9.12 Replace the oil rings
127
11.9.13 Replace the piston
131
11.10 Safety block
135
11.10.1 Safety block for 200bar devices
135
11.10.2 Safety block for 350/500bar devices
137
11.11 Burner blower with fuel pump
138
11.11.1 Change fuel filter
138
11.11.2 Dismantling the fuel pump
138
11.11.3 Dismantling the burner blower
139
11.11.4 Motor burner blower: Changing the carbons
142
11.11.5 Cleaning the air duct
143
11.12 Booster heater
144
11.12.1 Dismantling / cleaning the burner cover
144
11.12.2 Adjusting the ignition electrodes
145
11.12.3 Changing the ignition transformer
146
11.12.4 Cleaning / changing the flame sensor
146
Summary of Contents for HDS 9/50 De Tr1
