Kärcher 1.047-310.0, Manual

Page: 28 / 402

-
12
Troubleshooting
Fault Remedy
Appliance cannot be started Sit on the driver seat, the seat contact switch gets activated.
Check, if the stop switch on the combustion engine is in the "ON" position.
Refuel
Open fuel cock
Check fuel pipes, connections and joints and maintain them if required
Charging battery
Check and clean spark plug, replace if necessary.
Inform Kärcher Customer Service.
Engine is running erratically Clean or replace air filter
Check fuel pipes, connections and joints and maintain them if required
Inform Kärcher Customer Service.
Engine is running but machine is
not moving Check setting of freewheel lever
Inform Kärcher Customer Service.
Engine is running but machine is
only moving slowly Allow machine to warm up for approx. 3 minutes in sub-zero temperatures
Inform Kärcher Customer Service.
Machine is not sweeping properly Check roller brush and side brushes for wear, replace if necessary.
Check function of bulk waste flap
Check sealing strips for wear, adjust or replace as required
Check belts of sweeping drive.
Inform Kärcher Customer Service.
Dust gathers in the machine
Insufficient vacuum performance Empty waste container
Check hoses of suction blower for absence of leakness.
Clean and check the dust filter, replace if necessary.
Check the dust filter for proper seating.
Close wet/dry flap
Check sealing strips for wear, adjust or replace as required
Inform Kärcher Customer Service.
Side brush or roller brush is not be-
ing lowered; under-pressure sys-
tem is defective Inform Kärcher Customer Service.
Roller brush does not turn. Set programme switch to stage 2 or 3.
Remove belts or cords from roller brush
Check V-belt tension
Inform Kärcher Customer Service.
The motor cannot be switched off
(Key position on "0") Open the appliance cover and close the petrol cock. Risk of injury on account of rotating belts!
Close the cover and wait until the motor turns off.
28 EN