
6. Data Output
20
6.3 Printing out Measurement Data
To print out stored measurement data, a printer cable must be connected
to the RS232C terminal located at the side of the instrument.
Note1
:
Although you can see both RS232c mark (
) and USB mark (
)
near the
terminal, only RS232c is available for this instrument.
6.3.1 Preparation for Print Out
<Need to prepare>
- Printer (optional)…recommended model: DPU-H245 (Seiko Instruments)
- Printer Cable (optional)
<Baud rate setting>
The baud rate setting of the instrument and printer must be consistent.
List of communication protocol for IAQ Monitor:
Data Bit Length
8 bit
Parity
None
Stop Bit
1
Delimiter
CRLF
Baud Rate
Based on the set value*
* As for setting BAUD RATE, refer to “7.2 Changing Measurement Unit and Baud Rate” (Page 30).
* As for setting the printer, refer to the printer’s operation manual.
<Connecting the instrument with a printer >
1.
Connect a printer to the instrument by inserting a connecting cable into RS232 terminal located at the side of the
instrument.
2.
Turn ON the power of the instrument first, and then turn ON the printer.
3.
Make sure that the instrument is in NORMAL Mode.
6.3.2 Printing from the NORMAL (Measurement) Mode
Display
Procedure
When a NORMAL mode screen is displayed, press
key to HOLD
the readings that you want to print out.
Press key to print out the display which is on hold at the time.
If a printer is not connected properly, “PERR” will be displayed in lower
left of the display.
Examples of Data Printout
<NORMAL Mode
>
2004/05/12 15:40:45
CO2 523 PPM
CO 1.7 PPM
Temperature 24.4 ゚ C
Humidity 52.7 %RH
…………CO
2
…………CO
…………Temperature
…………Humidity
RS232C
Terminal
(Note 1)
<Side of the Instrument>
Summary of Contents for 2212
Page 52: ...13 Contact Information 49 ...