Fitting the overrun braking mechanism of the non-adjustable towbar:
Fig. 21 Fitting the overrun braking mechanism of the non-adjustable towbar
1
Overrun braking mechanism
2
Lever with securing sleeve
3
Brake transfer cable
4
Brake rod
5
Towbar
6
Securing bolts
7
Washer
8
Hexagon nut (self-locking)
9
Hexagon nut (locknut)
10
Locknut
A
Front screw fastening brake transfer cable
B
Rear screw fastening brake transfer cable
1. Push the overrun braking mechanism onto the towbar and position so that the securing bolts
can be pushed on.
2. Push in the securing bolts (using light hammer blows if necessary) and push on U-washers.
3. Secure the bolts with the self-locking nuts (see chapter 2.4.4 for tightening torque).
4. Screw in the front screw fastening of the brake transfer into the securing sleeve of the overrun
braking mechanism and secure with a lock nut.
5. Suspend the brake transfer cable in each of the two fastening lugs on the towbar and tighten
the clamping nuts.
6. Screw the the brake-rod linkage onto the rear screw fastening of the brake transfer cable and
secure with a lock nut.
Further information Further information on setting the brake actuating rod is to be found in chapter 10.7.3.3.
6
Installation
6.3
Fitting the towbar
No.: 9_6974 20 E
Service manual Portable compressor
M122
51
Option sd, sh
RAMIRENT
