Fig. 21 Fitting the EPC 340 sound enclosure
1
Rubber pad
2
Rubber pad
3
Z-profile
4
Bracket
5
Rubber pad
6
Base plate
7
Compressor block
8
Serrated locknut
9
Fan with cowl
10
Pre-cut foam
11
User's check valve
12
Hose line
13
Sound enclosure
14
Air inlet louver
15
Removable panel
16
Snap fastener
1. Place the Z-profiles on the brackets, insert the rubber pads
1
through the brackets and Z-pro‐
files and secure with serrated locknuts.
2. Insert rubber pads
2
through the Z-profiles and secure with serrated locknuts.
3. Position the base plate and secure with hex-head screws to the rubber pads
2
.
4. Insert the rubber pads
5
through the base plate and secure to the Z-profiles.
5. Place the compressor block on the base plate and screw to the rubber pads
5
.
6. Slide the pre-cut foam over the fan cowl.
7. Lead the motor cable and hose line through the holes provided and connect up.
8. Attach the sound enclosure to the base plate.
9. Screw the inlet air inlet louvre to the enclosure, hang the panel (exhaust louvre) in the enclo‐
sure and secure it with the snap fasteners.
6
Installation
6.10 Retrofitting the sound enclosure (accessory)
No.: 9_5752 24 E
Assembly and operating manual 1-stage piston compressor
EPC-G
47
