Kaco blueplanet 15.0 TL3, Manual, Page: 19 / 96

6.4 Installing and securing the device
CAUTION
Risk of injury from improper lifting and transport.
If the device is lifted improperly, it can tilt and result in a fall.
1. Always lift the device vertically using the openings provided.
2. Use a climbing aid for the chosen installation height.
3. › Wear protective gloves and safety shoes when lifting and lowering the device.
NOTE
Power reduction due to heat accumulation!
If the recommended minimum clearances are not observed, the device may go into power regulation mode
due to insufficient ventilation and the resulting heat build-up.
1. › Observe minimum clearances and provide for sufficient heat dissipation.
2. All objects on the device housing must be removed during operation.
3. › Ensure that no foreign bodies prevent heat dissipation following device installation.
1
2
3
Fig. 14: Lift the device using the housing
NO
5
4
Fig. 15: Fitting the device onto the mount
Key
1 Opening 4 Interlock in mount
2 Centre of gravity 5 Fastening lug
3 Recess to allow visibility during mounting process
Lifting and installing the device
↻
The mount has been installed.
1. Lift the device using the lateral openings [See figure 14 [ } Page 19]. Observe the device's centre of gravity!
2. Suspend the device in the mount using the recess on the rear of the device [See figure 15 [ } Page 19]
3. Insert the screw provided into the lug of the mount and secure the device to prevent it from being lifted off X Z2
(Pozidrive) / 1 Nm] [See figure 12 [ } Page 18].
.
NOTE: Alternatively: At this point, the screw described above can be replaced by a special screw as
anti-theft protection.
ð Device is installed. Proceed with the electrical installation.
Manual Assembly and preparation | 6
KACO blueplanet 15.0TL3 KACO blueplanet 20.0TL3
Page 19
EN