Kaco blueplanet 15.0 TL3, Manual, Page: 18 / 96

6. Place the protective packaging back into the carton.
7. Lift the device at the intended positions.
ð Continue mounting the device.
6.3 Fastening the mount
WARNING
Hazard when using unsuitable fixing materials!
If unsuitable fixing materials are used, the device could fall and persons in front of the device may be seriously
injured.
1. Use only fixing materials that are suitable for the mounting base. The fastening materials supplied are only
to be used for masonry and concrete.
2. Only install the device in an upright hanging position.
1
2
3
4
5
65,5 mm
A
A
D
C
C
B
B
Fig. 12: Minimum clearances for wall mounting
1120 mm
1386 mm
260 mm
405 mm
565 mm
328 mm
*
315 mm
Fig. 13: Position of wall bracket / suspension
Key
1 Mount 4 Screw for securing purposes (1x)
2 Fixings for mounting [S6 – Ø 6mm/ 60mm] 5 Bracket to prevent device displacement
3 Screw for mounting 5x 5x50 [Z2+Slot 5x50 [See sec-
tion 6.3
}
Page 18]]
A Minimum clearance: 250 mm (without device315
mm )
recommended distance405 mm (without device 340
mm *) C Minimum clearance: 700 mm
B Minimum clearance: 500 mm D Recommended clearance: 250 mm
↻
Cardboard packaging with mount and mounting kit removed from the packaging and opened.
1. Mark the mounting position on the wall surface according to the position of the mount by drawing a line.
2. Mark the positions of the drill holes using the slot in the mount.
.
NOTE: The minimum clearances between two devices, or the device and the ceiling or floor have
already been taken into account in the diagram.
3. Fix the mount to the wall using suitable mounting fixtures from the mounting kit.
. NOTE: Make sure that the mount is oriented correctly.
ð
Proceed with the installation of the device.
6 | Assembly and preparation Manual
KACO blueplanet 15.0TL3 KACO blueplanet 20.0TL3 Page 18
EN