Kaco blueplanet 15.0 TL3, Manual, Page: 21 / 96

7 Installation
7.1 Opening the device
NOTE
Removing the upper housing cover will invalidate the warranty.
Only ever release and remove the lower housing cover. Opening the upper housing cover will invalidate your
warranty.
↻ The device has been installed on the mount.
↻
Wipe any moisture off the frame of the housing cover using a cloth.
1. Undo the 4 screws (2) and carefully remove the housing cover (1) [ T_30]
2. Be careful not to damage or soil the seal when setting the housing cover down.
ð
Proceed with the installation of the device.
2
1
7.2 Surveying the connection area
The connection for the AC supply is located inside the housing. The DC input source is connected to the housing
base via the solar plug connectors.
4
3
5
1
2
Fig. 16: Connection area
Key
1 DC isolator switch 4 Cable fitting (M40) for AC connection
2 8 (2x4) MC-compatible DC connectors for PV
generator 5 Cable fitting (M16) for housing ground connec-
tion
3 AC connection terminal
7.3 Making the electrical connection
NOTE
Select conductor cross-section, safety type and safety value in accordance with the following basic
conditions:
Country-specific installation standards; power rating of the device; cable length; type of cable installation; local
temperature
7.3.1 Requirement for supply lines and fuse
DC-side
Max. conductor cross-section dependent on the plug that is used
Min. cable cross-section
Manual Installation | 7
KACO blueplanet 15.0TL3 KACO blueplanet 20.0TL3
Page 21
EN