Kaco blueplanet 15.0 TL3, Manual, Page: 91 / 96

↻ Ensure there is no AC/DC voltage present.
↻ Check that there is no current using a clip-on ammeter.
↻ NOTE: Plug connectors may be unplugged under voltage, but never
under load.
1. Use a screwdriver (blade width 3 mm) to push out the latch on the coupling.
2. Leave the screwdriver in place.
3. Disconnect the DC connector from the DC socket.
1
2
1
2
Fig. 62: Unplugging the plug connector
1 Screwdriver
2 Latch
12.3 Uninstalling the device
DANGER
Dangerous voltage due to two operating voltages
Severe injuries or death may occur if the cables and/or terminals/busbars in the device are touched. The dis-
charge time of the capacitors is up to 5 minutes.
1. Only appropriately qualified electricians authorised by the mains supply network operator are permitted to
open and maintain the device.
2. Before opening the device: Disconnect the AC and DC sides and wait at least 5 minutes.
↻ Device disconnected and secured against restart.
1. Undo the 4 screws and carefully remove the housing cover [ T_30]
2. Remove the interface cables.
3. Open the AC cable lock on the printed circuit board connection terminal.
4. Detach the equipotential bonding cable from the grounding point [ T_30]
5. Detach the interface cables from the printed circuit board connection terminal.
6. Detach from the DC cables from the DC plug connectors and furnish with protective caps.
7. Open the cable fittings [ W_46 / W_29 / W_20].
8. Pull the cables out of the device.
ð The device is uninstalled. Proceed with disassembly.
12.4 Disassembling the device
↻ Unit has been switched off and uninstalled.
1. Remove the screw that prevents the device from being lifted off the mount.
2. Use the lateral openings and lift the device off the mount.
ð Device removed. Proceed with the packaging process.
12.5 Packaging the device
↻ Device has been uninstalled.
1. If possible, always pack the device in the original packaging. If this is no longer available, an alternative is to
use equivalent packaging.
2. You must be able to close the box completely and it must be able to accommodate the weight and size of
the device.
Manual Decommissioning and dismantling | 12
KACO blueplanet 15.0TL3 KACO blueplanet 20.0TL3
Page 91
EN