5
Mount the dome cover to the camera.
0
Use the screws (x4) to mount the dome cover
to the camera. When installing the dome
cover, make use of the three catches and the
center mark of the cover as a guide. Install
such that the central mark appears above the
JVC mark of the camera.
.
Center
mark
(facing the JVC mark)
Position alignment catches (x3)
Note :
0
Check that there is no dirt or dust inside the
dome cover before mounting.
0
When installing on a rainy day, ensure that
raindrops do not enter the interior.
0
When mounting the dome cover, temporarily
secure the four screws and then tighten.
0
As a guide, tighten the screws to 0.5
N·m to
1
N·m (5
kgf·cm to 10
kgf·cm). If the screws are
insufficiently tightened, the dome cover may fog
due to moisture penetration.
6
Remove the cable connection cap.
0
Remove the cap on the arm of the camera.
.
Cable
connection cap
7
Pull out the cables from the cable
connection hole.
0
Pull out the cables (except the fall prevention
wire) of the camera from the cable
connection hole.
Preparation for installation and connection is
now complete. Next, mount the camera unit.
34
Installation and Connection Preparations (VN-H657WPBU)
Moun
tin
g
the
Ca
m
era
