9
Status
This is indicated as “Recording” when recording is
in progress, and as “No Recording” when recording
is stopped. When only [Alarm] is selected, the
status is indicated as “Recording” when an alarm
trigger is detected, and as “No Recording” when an
alarm trigger is not detected.
Recording Mode
For setting the mode for recording to the SD card.
You can select [Constant], [Alarm], or [Network
Outage].
[Set values: Constant, Alarm, Network Outage]
Memo :
0
When [Record Status] is “ON”, the [Recording
Mode] setting cannot be changed.
0
To change the [Recording Mode], do so after
setting [Record Status] to “OFF”, followed by
pressing the [OK] button to stop recording.
0
When [Record Status] is set to “OFF”,
[Recording Mode] is restored to the factory
default.
9
Constant
Regardless of whether there is an alarm, recording
to the SD card is performed at all times.
Erases the oldest record data and continues
recording when the SD card is full.
9
Alarm
Performs recording to the SD card when a trigger
that matches the preset conditions in [Alarm
Settings] is detected. The recording duration for an
alarm event during the occurrence of an alarm
trigger is about 120 seconds in total: 60 seconds
before the trigger (pre-trigger) and 60 seconds
after (post-trigger).
Selecting “Alarm” displays the [Alarm Settings]
item.
Memo :
0
If a new trigger is detected while alarm recording
is in progress, the recording duration will be
extended by about 60 seconds from the point of
detection.
0
Erases the oldest record data and continues
recording when the SD card is full.
9
Network Outage
Performs recording to the SD card when the link
between the camera and the network is
disconnected.
Memo :
0
If the LAN cable is unplugged while power is
supplied via PoE, both the link with the network
and the power supply will be disconnected. In
this case, recording to the SD card will not be
performed.
0
Erases the oldest record data and continues
recording when the SD card is full.
Note :
0
There are some network failures that do not
support network failure recording.
0
Our company shall not be liable for any accident
or damage that occurs.
Alarm Settings
For setting the corresponding alarm trigger when
“Alarm” is selected in [Recording Mode].
9
Trigger1
For selecting the first trigger for starting alarm
recording.
[Set values:
R
Pin Input1 Make, Pin Input1 Break,
Pin Input2 Make, Pin Input2 Break, Position, Audio
Detection1, Audio Detection2, Motion Detection,
Tampering Detection, Easy Day/Night, Time]
Memo :
0
The “Audio Detection1”, “Audio Detection2”,
“Motion Detection”, and “Tampering Detection”
settings for the trigger specified in [Trigger1]
need to be set to “ON” on the respective settings
pages under [Advanced Settings].
0
If the trigger for [Trigger2] is set to “Disable”,
alarm recording starts with only the trigger in
[Trigger1].
0
When “Audio Detection1”, “Audio Detection2”,
“Motion Detection”, “Tampering Detection”,
“Easy Day/Night”, or “Time” is selected for
[Trigger1], [Interval] and [Trigger2] cannot be
selected.
[Advanced Settings] Page -[SD Card Recording] Page
47
Se
tti
ng
Us
in
g In
ter
net
E
xplor
er
