Memo :
0
You can specify the file size by combining the
frame size and the picture quality level.
0
Select between Level
1 and 7. The picture
quality increases when the level value is small.
However, the file size increases.
0
The reference value per frame is displayed to
the right of the picture quality setting pull-down
menu.
0
There is a limit to the total number of pixels per
unit time that can be encoded simultaneously by
three encoders (total frame size and frame rate
processed by each encoder).
p.94 [Appendix (Restrictions during
9
Monitor Out
Set to “ON” when you are using monitor output.
[Set values: ON,
R
OFF]
Memo :
0
EncoderNo.2 and monitor output cannot be
enabled at the same time. Set one of them to
“OFF”.
0
If the settings on the [Encoding] page is changed
while monitor output is in use, the monitor output
image may be temporarily disrupted.
0
You can switch the video standard to “PAL” or
“NTSC” on the [Maintenance] page.
[Audio] Page
This is a page for specifying the audio settings.
This page can be used during access using
“admin” or “operator”.
0
Click [Advanced Settings] in the side menu, and
click [Audio].
0
Press the [OK] button to enable the new
settings.
0
If the [OK] button is pressed upon entering an
invalid value, a warning message will appear
and the entry will be denied. Press the [Cancel]
button to restore the invalid entry to the value
before the change was made. If you press the
[Cancel] button, other changed items will also be
restored to the values before the change was
made.
Settings
.
* Setting values with
R
are default values.
[Advanced Settings] Page -[Encoding] Page
37
Se
tti
ng
Us
in
g In
ter
net
E
xplor
er
