[Encoding] Page
This is a page for specifying settings on JPEG/H.
264 encoding.
The settings here are linked to the [Encode] item in
the [Basic Setting2] page.
p.29 [[Basic Setting2] Page] )
This page can be used during access using
“admin” or “operator”.
0
Click [Advanced Settings] in the side menu, and
click [Encoding].
0
Press the [OK] button to enable the new
settings.
0
If the [OK] button is pressed upon entering an
invalid value, a warning message will appear
and the entry will be denied. Press the [Cancel]
button to restore the invalid entry to the value
before the change was made. If you press the
[Cancel] button, other changed items will also be
restored to the values before the change was
made.
0
There is upper limit to transmission bit rate from
the camera. If a bit rate that exceeds upper limit
is specified, this new setting will not be applied.
For details on the maximum transmission limit,
refer to the following.
0
The contents displayed in “Encoder
No.1”,
“Encoder
No.2” and “Encoder
No.3“ change
depending on the type of encoding and the item
selected.
0
If the distribution bit rate exceeds 40 Mbps, the
specified frame rate distribution fails.
0
In cases such as high-bitrate distribution at a
frame size of 1920
´
1080 and frame rate of 30
fps (particularly slow pan operations), the
camera image may not appear smooth even on
a high-performance computer. In this case,
lower the [Framesize], [Framerate], and
[Bitrate], and check the image again.
Memo :
0
H.264 High indicates H.264 High Profile, and H.
264 Baseline indicates H.264 Baseline Profile.
Settings
.
* Setting values with
R
are default values.
Encode
Each of the three channels of the encoder can be
set to H.264 High, H.264 Baseline or JPEG, and a
different frame size can also be specified.
However, only one channel is available for H.264
Baseline, and therefore it cannot be set for multiple
encoders at the same time.
[Advanced Settings] Page -[Encoding] Page
35
Se
tti
ng
Us
in
g In
ter
net
E
xplor
er
