Installation and Connection
Preparations
0
Be sure to put on protective glasses to protect your
eyes from falling objects when mounting the
camera.
0
The fall prevention wire (for ceiling) is not
supplied. Make use of the wire while taking note
of its length, strength, pull and material
(insulation).
0
Attach the fall prevention wire (ceiling) to a place
with sufficient strength (ceiling slab, etc.).
1
Place the template against the ceiling,
and fasten the ceiling mount bracket
with three screws.
.
3 mm and below
25 mm and above
(Wooden screws: Φ4.1)
M4x3
2
Use the provided template, and make
a hole (Φ25 mm) to route the
connection cables and fall prevention
wire (ceiling) into the ceiling.
.
3
Press the tab on the adapter side of the
cable cover inward to remove the
cable cover, and attach the fall
prevention wire connected to the
ceiling mount bracket to the camera.
.
4
Connect the power cable.
0
To supply power from an AC 24 V or a DC 12
V power supply, connect a power cable.
0
To supply power via PoE, do not connect a
power cable. Go to the next step.
p.19 [Remove the protective sheet
The following table shows the connection
distances and connection cables provided
that 2-conductor VVF cables
(vinyl-insulated vinyl sheath cables) are
used. (Reference value)
Conductor
Diameter
Maximum Connection
Distance
DC 12 V
AC 24 V
Φ1.0 mm
(AWG18)
18 m
(59 ft)
57 m
(187 ft)
Φ1.6 mm
(AWG14)
48 m
(157 ft)
145 m
(475 ft)
Memo :
0
The default IP address setting is 192.168.0.2.
Note :
0
For safety reasons, turn on the power only after
ensuring that all the connections are in place.
0
Do not supply power through the power cable
and LAN cable at the same time.
0
If multiple cameras are turned on
simultaneously in the same LAN environment,
access attempts may fail due to IP address
duplication. Set up an IP address by either using
the JVC-VN-IP SettingTool (included on the
supplied CD-ROM) or turning the power supply
of each camera on separately to avoid
duplication.
Caution
To supply power to this product, make use of AC
24 V 50 Hz/60 Hz, DC 12 V or PoE
(IEEE802.3af). Make use of the correct voltage.
Be sure to use an AC 24 V or DC 12 V supply that
is isolated from the primary power supply circuit.
Supplying a power beyond the rated value may
result in failures, smoke or fire. If the camera
breaks down, turn off the power and contact our
service center immediately.
When a power beyond the rated value is
supplied, the internal components may be
damaged even if no abnormality is found on the
appearance and operation of the camera.
Please contact our service center immediately
for servicing (charged separately).
18
Installation and Connection Preparations
Moun
tin
g
the
Ca
m
era
