CAUTION:
You must power off the external Routing Engine before you remove or
insert a VCCI module.
To remove a VCCI module from an external Routing Engine (see
):
1. Place the antistatic bag or the antistatic mat on a flat, stable surface.
2. Power off the XRE200 Routing Engine. See
“Powering Off an XRE200 External Routing Engine” on
3. Unscrew both captive screws counterclockwise using your fingers. If you are unable to easily unscrew
the captive screws with your fingers, use the screwdriver.
4. Gently pull the VCCI module toward you and out of the VCCI module slot, being careful to keep one
hand underneath the module to support it when it is removed from the chassis.
5. Place the VCCI module in the antistatic bag or on the antistatic mat.
Figure 36: Removing a VCCI Module from an XRE200 External Routing Engine
g020971
Loosen captive screws.
SEE ALSO
Virtual Chassis Control Interface (VCCI) Modules in an XRE200 External Routing Engine | 42
100
Summary of Contents for XRE200 -
