Juniper SRX5600, Hardware Manual

Page: 268 / 483

Power 2
11.3 V bias PEM 11253 mV
4.6 V bias MidPlane 4814 mV
11.3 V bias FPD 11234 mV
11.3 V bias POE 0 11176 mV
11.3 V bias POE 1 11292 mV
Bus Revision 42
FPGA Revision 1
To check the status of a specific SCB, issue the show chassis environment cb node slot command, for
example, show chassis environment cb node 0.
For more information about using the CLI, see the CLI Explorer .
Taking the SRX5600 Services Gateway Host Subsystem Offline
The host subsystem is composed of an SCB with a Routing Engine installed in it. You take the host subsystem
offline and bring it online as a unit. Before you replace an SCB or a Routing Engine, you must take the host
subsystem offline. Taking the host subsystem offline causes the device to shut down.
To take the host subsystem offline:
1. On the console or other management device connected to the Routing Engine that is paired with the
SCB you are removing, enter CLI operational mode and issue the following command. The command
shuts down the Routing Engine cleanly, so its state information is preserved:
user@host>
request system halt
2. Wait until a message appears on the console confirming that the operating system has halted.
For more information about the command, see Junos OS System Basics and Services Command Reference
at www.juniper.net/documentation/ .
NOTE: The SCB might continue forwarding traffic for approximately 5 minutes after the
request system halt command has been issued.
271