Juniper NFX150, Hardware Manual

Page: 88 / 152

To install the LTE expansion modules such as NFX-LTE-AE and NFX-LTE-AA in an NFX150
device:
1.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
the strap to the grounding point on the back of the device.
2.
Power off the device using the following command:
request system power-off
3.
Remove both the blank modules installed on the device:
•
Loosen the screws on the faceplate of the blank module.
•
Grasp the screws on each side and remove the blank module.
4.
Remove the LTE expansion module from the electrostatic bag.
5.
Grasp the screws on each side of the module faceplate and align the notches in the
connector at the rear of the module with the notches in the module slot in the device.
6.
Slide the module in until it lodges firmly in the services gateway.
7.
Using a 1/8-in. (3-mm) flat-blade (–) screwdriver, tighten the screws on each side of
the module faceplate.
8.
Remove the cover from the SIM slot, SIM 1. Insert the SIM card into the SIM slot. You
can use the other slot, SIM 2, for installing a secondary SIM.
9.
Replace the cover over the SIM slots.
10.
Attach the antennas to the chassis. See Figure 41 on page 88 .
Figure 41: Attaching Antennas to the LTE Expansion Module
g10005
9
NFX-LTE-AA
SIM1
SIM2
AUX
MAIN
11.
Power on the device.
Copyright © 2018, Juniper Networks, Inc. 88
NFX150 Network Services Platform Hardware Guide