Juniper NFX150, Hardware Manual

Page: 105 / 152

user@switch> request system halt
This command shuts down the device gracefully and preserves system state
information. A message displays on the console confirming that the operating system
has halted.
You will see the following output (or something similar, depending on the hardware
being shut down):
user@switch> request system halt
warning: This command will halt all the members.
If planning to halt only one member use the member option
Halt the system ? [yes,no] (no) yes
*** FINAL System shutdown message from user@switch ***
System going down IMMEDIATELY
Shutdown NOW!
[pid 14102]
message sent
{master:0}
user@switch> Waiting (max 300 seconds) for system process `vnlru' to stop...done
Waiting (max 300 seconds) for system process `vnlru_mem' to stop...done
Waiting (max 300 seconds) for system process `bufdaemon' to stop...done
Waiting (max 300 seconds) for system process `syncer' to stop...
Syncing disks, vnodes remaining...3 3 1 2 2 0 0 0 0 done
syncing disks... All buffers synced.
Uptime: 38d18h0m6s
recorded reboot as normal shutdown
The operating system has halted.
Please press any key to reboot
CAUTION: The final output of any version of this command is the
The
operating system has halted. Please press any key to reboot.
message. Wait
for at least 60 seconds after seeing this message and before following
the instructions in Steps 3 and 4 to power off the device.
CAUTION: Ensure that you have halted your system safely before turning
off the power supply.
3.
Wrap and fasten one end of the ESD grounding strap around your wrist and connect
the other end to a site ESD point.
4.
Set the power switch to OFF (O) position.
105 Copyright © 2018, Juniper Networks, Inc.
Chapter 4: Maintaining Components