Juniper JUNOSE 11.1.X - QUALITY OF SERVICE CONFIGURATION GUIDE 3-21-2010, Configuration Manual

Page: 328 / 398

Table 31: Byte Adjustment Values for Frame and Cell Shaping Modes
Final Byte
Adjustment
Value Configured
qos-byte-adjustment
Value Configured
qos-frame-byte-adjustment
Value
Shaping Mode
on Port 0
-4 -4 Any value Cell
0 Undefined Any value Cell
0 Undefined Undefined Frame
8 -4 8 Frame
8 8 Undefined Frame
Related Topics
■
Configuring a Parameter Definition to Adjust Cell Shaping Rates for ADSL Traffic
on page 297
■
Configuring a Parameter Definition to Adjust Frame Shaping Rates for VDSL
Traffic on page 299
■
Example: QoS Parameter Configuration for QoS Cell Mode and Byte Adjustment
for Cell Shaping on page 286
■
For more information about configuring shaping modes for Ethernet, see QoS
Shaping Mode for Ethernet Interfaces Overview on page 178 and Cell Shaping
Mode Using QoS Parameters Overview on page 281
■
For more information about shaping the downstream rate using QoS parameter
instances that were created dynamically by ANCP, see QoS Downstream Rate
Application Overview on page 301
Guidelines for Configuring Byte Adjustment of Cell and Frame Shaping Rates Using
QoS Parameters
When you specify the cell or frame byte-adjustment application, the following
considerations apply:
■
You can have only one QoS parameter definition with the cell byte-adjustment
application (
qos-byte-adjustment ) configured.
■
You can only have one QoS parameter definition with the frame byte-adjustment
application (
qos-frame-byte-adjustment ) configured.
■
You can specify only instance-interface types of lag, ethernet, svlan, and vlan.
■
You can specify only an subscriber-interface type of vlan.
■
The available range for parameters with the byte adjustment application is -32–63.
You cannot configure another range using the
range command.
296 ■
Guidelines for Configuring Byte Adjustment of Cell and Frame Shaping Rates Using QoS Parameters
JUNOSe 11.1.x Quality of Service Configuration Guide