Juniper JUNOSE 11.1.X - QUALITY OF SERVICE CONFIGURATION GUIDE 3-21-2010, Configuration Manual

Page: 166 / 398

■
qos-profile
■
queue
Attaching a QoS Profile to an Interface
You can attach a QoS profile to the base of an interface hierarchy, to a specific ATM
VP or S-VLAN, or to a port type.
Tasks to attach a QoS profile include:
■
Attaching a QoS Profile to a Base Interface on page 134
■
Attaching a QoS Profile to an ATM VP on page 134
■
Attaching a QoS Profile to an S-VLAN on page 135
■
Attaching a QoS Profile to a Port Type on page 135
Attaching a QoS Profile to a Base Interface
You can attach a QoS profile to an interface at the base of an interface hierarchy.
Interface types below the attachment point cannot be referenced in the QoS profile.
To attach a profile to an interface:
1.
Enter Interface Configuration mode for the interface.
host1(config)# interface gigabitEthernet 2/0
2.
Attach a QoS profile to the interface.
host1(config-if)# qos-profile qosp-ethernet-queuing
Attaching a QoS Profile to an ATM VP
You can associate a QoS profile with all the ports of a certain interface type.
You can attach a QoS profile to an ATM VP. The profile applies to all VCs in the VP;
for example, the profile specifies the scheduler hierarchy of scheduler nodes and
queues for all VCs, IP interfaces, and L2TP sessions stacked above the VP.
To attach a profile to an ATM VP:
1.
Enter Interface Configuration mode for the interface.
host1(config)# interface atm 1.0/1
2.
Attach a QoS profile to the ATM VP.
host1(config-if)# atm-vp 50 qos-profile qosp-vp-strictbw
134 ■
Attaching a QoS Profile to an Interface
JUNOSe 11.1.x Quality of Service Configuration Guide