Juniper JUNOSE 11.1.X - QUALITY OF SERVICE CONFIGURATION GUIDE 3-21-2010, Configuration Manual

Page: 227 / 398

Configuring the System to Dynamically Rebalance the LAG
To configure the system to dynamically rebalance the LAG:
1.
Specify the LAG interface.
host1(config)# interface lag lg1
2.
Issue the load balance command with no keywords:
host1(config-if)# load-rebalance
Related Topics
■
Configuring Load Rebalancing for 802.3ad Link Aggregation Groups on page 193
■
QoS for 802.3ad Link Aggregation Interfaces Overview on page 183
■
Enabling Default Subscriber Load Balancing for 802.3ad Link Aggregation Groups
on page 191
■
Configuring the Scheduler Hierarchy for Subscriber Load Balancing in 802.3ad
Link Aggregation Groups on page 192
■
interface lag
■
load-rebalance
Monitoring QoS Configurations for 802.3ad Link Aggregation Groups
To monitor Ethernet configurations for QoS:
■
Monitoring the QoS Configuration of Fast Ethernet, Gigabit Ethernet, and
10-Gigabit Ethernet Interfaces on page 347
■
Monitoring the QoS Configuration of IEEE 802.3ad Link Aggregation Group
Bundles on page 349
■
Monitoring the QoS Configuration of IP Interfaces on page 345
■
Monitoring the QoS Profiles Attached to an Interface on page 339
■
Monitoring the Configuration of QoS Port-Type Profiles on page 340
■
Monitoring the Configuration of QoS Profiles on page 341
■
Monitoring the QoS Scheduler Hierarchy on page 322
■
Monitoring Shared Shapers on page 329
Configuring the System to Dynamically Rebalance the LAG
■ 195
Chapter 21: Configuring QoS for 802.3ad Link Aggregation Groups