Juniper JUNOSE 11.1.X - QUALITY OF SERVICE CONFIGURATION GUIDE 3-21-2010, Configuration Manual

Page: 337 / 398

host1(config-if)# ip address 6.10.10.10 255.255.255.255
Related Topics
■
Example: QoS Parameter Configuration for QoS Downstream Rate on page 305
■
For information about downstream rate and RADIUS, see JUNOSe Broadband
Access Configuration Guide
■
For more information about configuring ANCP (L2C) parameters, see JUNOSe IP
Services Configuration Guide
■
aaa qos downstream-rate
■
controlled-interface-type
■
encapsulation vlan
■
instance-interface-type
■
ip address
■
node
■
qos-parameter
■
qos-adaptive-mode
■
qos-parameter-define
■
qos-profile
■
queue
■
shared-shaping-rate
■
subscriber-interface-type
■
traffic-class
■
vlan id
Example: QoS Parameter Configuration for QoS Downstream Rate
This example illustrates how to use parameters to control the downstream rate
obtained from ANCP.
In this example, the subscribers on the 0.1 access loop are configured on VLAN1.
They subscribe to voice, video, and data traffic with a bandwidth of 10 Mbps.
Subscribers on the 1.1 access loop are configured on VLAN2, and subscribe to 1 Mbps
of data traffic.
Table 33 on page 306 lists the shaping mode and shaping rate information received
by the QoS downstream rate application upon access loop synchronization. The
parameter instances are created with these values.
Example: QoS Parameter Configuration for QoS Downstream Rate
■ 305
Chapter 30: Configuring the Downstream Rate Using QoS Parameters