Juniper JUNOSE 11.1.X - QUALITY OF SERVICE CONFIGURATION GUIDE 3-21-2010, Configuration Manual

Page: 274 / 398

Creating Parameter Instances
You can create QoS parameter instances globally, for an interface, or for a
subinterface.
Tasks to create parameter instances are:
■
Creating a Global Parameter Instance on page 242
■
Creating a Parameter Instance for an Interface on page 242
■
Creating a Parameter Instance for an ATM VP on page 242
■
Creating a Parameter Instance for an S-VLAN on page 243
Creating a Global Parameter Instance
To create a global parameter instance:
■
Create a parameter instance in Global Configuration mode.
host1(config)# qos-parameter max-subscriber-bandwidth 6000000
Creating a Parameter Instance for an Interface
To create a parameter instance for an interface:
1.
Specify an interface.
host1(config)# interface atm 11/0.1
host1(config)# interface gigabitEthernet 2/0
2.
Specify the parameter name and the value.
host1(config-subif)# qos-parameter max-subscriber-bandwidth 6000000
Creating a Parameter Instance for an ATM VP
Use this procedure to attach a parameter instance to a VP on the interface. Optionally,
use the
qos-profile keyword to attach a parameter instance to a QoS profile.
To create a parameter instance for an ATM VP:
1.
Configure the ATM VP.
host1(config)# interface atm 2/0
host1(config-if)# atm vp-tunnel 4
2.
Do either of the following:
■
Attach the parameter instance to an ATM VP on the interface.
host1(config-if)# atm-vp 4 qos-parameter max-subscriber-bandwidth 375000
242 ■
Creating Parameter Instances
JUNOSe 11.1.x Quality of Service Configuration Guide