LB management
eNet radio centre plate
Parameters
Setting options, Basic
setting
Explanations
Dim down ramp
0 s … 24 h
Basic setting: 0 s
Time until reaching minimum brightness. The
light is dimmed to minimum brightness and then
switched off. Only applies to switch-off with trans-
mitters (short operation). If scenes are recalled or
switching uses logic modules, the system
switches off directly.
Run-on time
0 s … 24 h
Basic setting: 0 s
If a run-on time is entered and the "Use run-on
time" parameter is activated, the actuator no
longer remains permanently switched on, but
only for the duration of the run-on time entered
here or transmitted by a motion detector. The
run-on time is restarted if actuation is repeated.
A motion detector command without transmitted
run-on time (e.g. from an extension) leads to
switching on for the duration of the run-on time
entered here. If no run-on time is entered here,
the default run-on time of 2 minutes is applied.
Use run-on time
On, Off
Basic setting: Off
On:
If a run-on time is configured (≠ 0 s), in addition
to motion detector commands, all switching or
dimming commands also lead to switching on for
the duration of the run-on time.
If no run-on time is configured (= 0 s), all switch-
ing or dimming commands result in permanent
switching of the load.
As soon as the attachment receives a motion de-
tector command, the transmitted run-on time is
automatically entered in the "Run-on time" para-
meter and this then also applies to all switching
and dimming commands.
Off:
Only motion detector commands lead to switch-
ing on for the duration of the transmitted or set
run-on time. The load is permanently switched for
switching and dimming commands.
Manual switch-off
of the run-on time
On, Off
Basic setting: Off
Allows manual switch-off of a running run-on
time. If the parameter is switched off, then a
switch-off command will also switch the actuator
on. Only visible if a run-on time was set.
Switch on to last
brightness
On, Off
Basic setting: Off
Allows you to switch the lighting on at the same
brightness value that was used before it was last
switched off.
With the "Off" setting, the lighting is switched on
with the brightness saved in the "Switch-on
brightness" parameter.
15 / 29
32597903
07.08.2019
J0082597903
