Jung FM 1701 Series, Operating Instructions Manual

Page: 20 / 29

LB management
eNet radio centre plate
Parameters Setting options, Basic
setting Explanations
Behaviour after
the end of the
disabling function no change
Last value
Down
up
Basic setting: No
change Behaviour of the output when a block is removed.
Manual saving of
the scene values On, Off
Basic setting: On Disables the saving of the current Venetian blind
position as scene value in an actuator for a com-
mand via a transmitter.
Disable wind
alarm via exten-
sion On, Off
Basic setting: Off If the function is switched on, the UP signal no
longer has increased priority via an extension
and can be stopped via local control or radio con-
trol.
Note: In order to be able to use the wind alarm
function via the extension, this function must be
switched on.
Priority, lock-out
protection 0...4
Basic setting: 1 Specifies the priority for recalling and removing a
scene of type Lock-out protection for the channel.
Activate lock-out
protection blind
position 0 ... 100 %
Basic setting: 0 % Defines the behaviour of the output on activating
the lock-out protection.
Activate lock-out
protection slat
position 0 ... 100 %
Basic setting: 0 % Defines the slat position of the output on activat-
ing the lock-out protection. Only visible when the
Venetian blind operating mode is set.
Deactivate lock-
out protection
blind position 0 ... 100 %
Basic setting: 0 % Defines the behaviour of the output on deactivat-
ing the lock-out protection. Only visible when the
priority for the lock-out protection is 0.
Deacitvate lock-
out protection slat
position 0 ... 100 %
Basic setting: 0 % Defines the behaviour of the output on deactivat-
ing the lock-out protection. Only visible when the
priority for the lock-out protection is 0 and the
Venetian blind operating mode is set.
Priority, restraint 0...4
Basic setting: 2 Specifies the priority for recalling and removing a
scene of type Restraint for the channel.
Activate force op-
eration blind posi-
tion 0 ... 100 %
Basic setting: 0 % Defines the behaviour of the output on activating
the forced operation.
Recall forced op-
eration slat posi-
tion 0 ... 100 %
Basic setting: 0 % Defines the slat position of the output on activat-
ing forced operation. Only visible when the Vene-
tian blind operating mode is set.
Deactivate force
operation blind
position 0 ... 100 %
Basic setting: 0 % Defines the behaviour of the output on deactivat-
ing the forced operation. Only visible when the
priority for the forced operation is 0.
Deacitvate forced
operation slat po-
sition 0 ... 100 %
Basic setting: 0 % Defines the slat position of the output on deactiv-
ating forced operation. Only visible when the pri-
ority for the forced operation is 0 and the Vene-
tian blind operating mode is set.
Priority, wind
alarm 0...4
Basic setting: 3 Specifies the priority for recalling and removing a
scene of type Wind alarm for the channel.
20 / 29
32597903 07.08.2019
J0082597903