– 48 –
1. Inversion clamp is in the state of left-hand
at the start of sewing, and repeats left-hand
state and right-hand state alternately at each
time of inversion command. Accordingly it
is necessary to surely input the inversion
command with odd numbers, In case of even
numbers, the clamp and needle interfere with
each other at the end of sewing, and needle
may break
2. It is not possible to set the inversion point at
the positions below.
(a) Immediately after the 2nd origin
(b) Immediately after thread trimming
Inverson pont can be nputted only when the nverson state s set to the optonal nverson at clamp
nverson settng (
“9-2. Clamp inversion setting” p.93
).
(11) Inversion point (005)
1
Select the inversion point.
When selectng and executng INVERSION POINT (functon
code 005)
n the code lst screen, the left-hand
screen s dsplayed.
2
Perform setting of the inversion point.
When ENTER button
A
s pressed n the rght-hand
screen, the nverson pont s nputted to the present needle
poston, and the screen returns to the standard screen.
When nverson pont s nputted to the poston of
5
as shown
in the below figure, the linear sewing operation is performed
n the order of
3
→
4
→
5
(nverson)
→
6
→
7
→
3
after
jump feed from the orgn to
3
.
A
1
2
6
7
3
4
5
Inversion point
Origin
