– 41 –
When 2nd orgn s set at
3
of the jump feed secton n the
left-hand figure, the feed stops at
3
after jump feed of
1
→
2
→
3
, then the sewng machne performs the cycle operaton
of
3
through
9
.
1
Select thread trimming.
When selecting and executing THREAD TRIMMING (function
code 001)
n the code lst screen, the left-hand
screen s dsplayed.
2
Input thread trimming.
When ENTER button
A
s pressed n the left-hand
screen, thread trmmng s nputted, and the screen returns to
the standard screen.
Machne control command nputs varous control commands to the present pont.
(1) Thread trimming (001)
Thread trmmng can be optonally performed on the way of pattern data.
1
Set the present needle position to one point on the pattern
of jump feed.
2
Select the 2nd origin.
When selectng and executng 2ND ORIGIN (functon code 002)
n the code lst screen, the left-hand screen s dsplayed.
3
Input the 2nd origin.
When ENTER button
A
s pressed n the rght-hand
screen, the 2nd orgn s nputted, and the screen returns to
the standard screen.
(2) The 2nd origin (002)
Ths functon can set the 2nd orgn between the orgn and the sewng start pont, and specfy the
needle poston before the start of sewng moton. 2nd orgn can be set only on the way of jump feed.
This function has to set the present needle position
to one point on the pattern of jump feed beforehand.
When enlarging or reducing the pattern, the route
from the origin to the 2nd origin is not enlarged or
reduced.
1
2
7
6
8
4
5
3
9
2nd origin
Origin
A
A
4-5. Machine control command
