– 38 –
4-6. Adjusting the stacking board of the stacker
If sewng garment bodes wth pockets, adjust the
stackng board followng the steps descrbed below.
Ths adjustment allows the stacker to stack approx-
mately 140 peces of garment bodes wth pockets (
materal : T/C board cloth ). (When sewng garment
bodes wthout pockets, no adjustment s requred.)
1) When sewng men’s wear, loosen locknuts
2
n the reverse sde of stackng board
1
on the
rght sde, and rase the stackng board untl the
reverse side of the stacking board is flush with
the reverse sde of the locknut.
2) When sewng lades’ wear, loosen locknuts
2
n
the stackng board on the left sde as n the case
of men’s wear.
(When sewng garment bodes wthout pockets,
lower locknuts
2
untl they reach stackng board
base
3
and tghten them to the extent where
stackng board
1
s secured.)
Flush
WARNING:
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start of
the sewing machine.
1
2
3
WARNING:
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start of
the sewing machine.
30mm
If the materal drops at the tme
of stackng, stck a pece of adhe-
sve tape (30 mm) on the locaton
shown in the figure at left.
4-7. Preventive measure against the material dropping during stacking
Adhesive
tape
