− 84 −
Error
code
Descrpton of error
How to
recover
Place of
recovery
E061
Memory switch data error
When memory swtch data s broken or revson s old.
Turn OFF the
power.
-
E062
Sewing data error
When sewng data s broken or revson s old.
Turn OFF the
power.
-
E089
When sewing products are stacked and passing
Remove sewng products.
Possble to
re-start after
reset.
Automatc
sewng screen
E099
Interference of knife lowering command with
thread trimming motion
When nsertng poston of knfe command s mproper
and knfe command nterferes wth thread trmmng
moton n case of moton from external data.
Possble to
re-start after
reset.
Data nput
screen
E302
Confirmation of tilt of machine head
When tlt of machne head sensor s OFF.
Possble to
re-start after
reset.
Data nput
screen
E303
Main shaft semilunar plate sensor error
Semlunar plate of sewng machne motor s abnormal.
Turn OFF the
power.
-
E304
Cloth cutting knife sensor error
When knfe s held lowered or sensor s not OFF when
knfe s lowered.
Turn OFF the
power.
-
E401
Copy disapproval error
When tryng to perform copyng to the pattern No.
whch has been regstered.
Possble to
re-start after
pressng can-
cel button.
Pattern lst
screen
E402
Pattern deletion error
When tryng to perform deleton n case the remanng
pattern No. whch has been regstered s only one.
Possble to
re-start after
pressng can-
cel button.
Pattern lst
screen
E410
When sewing counter set value is smaller than the
number of times of sewing of the sewing pattern
which is selected at present.
Possble to
re-start after
reset.
AC data nput
screen
E478
Carriage movable range over error, left
Feed amount of sewng pattern s over the movable
range of carrage (left sde).
Set the jump feed amount and sewng length so that
the left travelng amount of carrage s wthn 25 mm.
Possble to
re-start after
reset.
AC data nput
screen
E479
Carriage movable range over error, right
Feed amount of sewng pattern s over the movable
range of carrage (rght sde).
Set the jump feed amount and sewng length so that
the rght travelng amount of carrage s wthn 610 mm.
Possble to
re-start after
reset.
AC data nput
screen
E486
Eyelet knife length error
When the shape s not formed snce the eyelet knfe
length s too short n case of eyelet shape.
Possble to
re-start after
reset.
Sewng data
nput screen
[S17]
E487
Eyelet shape length error
Eyelet shape length s too short to form the shape n
case of eyelet shape.
Possble to
re-start after
reset.
Sewng data
nput screen
[S14]
