21
21
21
21
has control of rudder and elevator only, while the master retains control of
throttle and aileron. Releasing the trainer switch returns all control to the
master transmitter. Be sure to reset the slave transmitter to its defaults by
using the reset function. All servo reversing, pitch and throttle curves etc. will
be taken from the master transmitter.
Use the scroll bar to rotate around the channels and toggle between master
and slave.
Note that when all channels are set to master, the trainer system becomes
NORNAL as indicated by the “NORMAL T.” on the screen.
Timer
The timer function provides an integrated timer for each model memory and a
countdown timer too. The integrated timer shows the total time the transmitter has
been turned on for that model, and the countdown timer is useful as a low fuel
warning.
Both timers are displayed when returning to the main screen. The countdown
timer is activated using either the bottom push button on the left hand side of the
screen or the trainer switch.
When the count down time is active, the transmitter will beep three times at 30
sec., twice at 20 sec., and beep once every second from 10 sec. to 0 sec. At
zero there will be a continuous tone for 1 second and then the timer will begin
counting up with a + indication to the left of the voltage display. When used as
the stopwatch, the timer will count up to 59 min. 59 sec. and then re-start
from zero.
