34
34
34
34
Both timers are displayed when returning to the main screen. The countdown
timer is activated using either the bottom push button on the left hand side of the
screen or the trainer switch.
When the count down time is active, the transmitter will beep three times at 30
sec., twice at 20 sec., and beep once every second from 10 sec. to 0 sec. At
zero there will be a continuous tone for 1 second and then the timer will begin
counting up with a + indication to the left of the voltage display. When used as
the stopwatch, the timer will count up to 59 min. 59 sec. and then re-start
from zero.
Servo Monitor
The PCM9X provides a servo monitor function screen that allows you to see the
actual real time travel of all 9 channels. This is a useful function to observe the
effects of mixing on your channels. All trim and mixing adjustments are shown.
Throttle Cut & Trim Select
The PCM9X features an intelligent throttle trim as well as a throttle cut function.
Only one or the other can be activated at a time. The
throttle cut
function turns
the trainer switch into an engine kill switch.
Use the software to determine a point at which the engine will stop. When the
switch is activated while at a low throttle setting the throttle servo will close to that
point for as long as the switch is being held.
