8
88
8
5. Transmitting mode transmitter (Tx with program to be transferred): Check
that the Transfer screen shows Transmit mode and press the CLR key to start
transmitting data. Both transmitters will indicate "End ok!" when the transfer
is complete.
When there is a data receiving failure during transfer, the counter will stop. At
this time, press the CLR key to stop the receiving condition. Check to be sure
the receiving counter is operating normally and ended with 100%. When the
receiving counter is stopped or you see ERROR indicated, check the trainer
cord conditions and try again. Be sure that the receiving mode transmitter is in
stand-by condition first. Also ensure that when transferring is complete,
previous data stored in the receiving side transmitter is replaced by the new
data transferred.
Note:
This function does not work when the battery alarm is flashing
(low battery).
Trim Step
The trim step function changes the coarseness of the digital trims from between 1
step per position to 10 steps per position.
