33
33
33
33
Normal Trainer System
In this mode, all functions are switched from the master to the slave using the
trainer switch. No function setup is necessary to activate this system. Be sure
the slave transmitter’s servo reversing, dual rates, end point adjustment and
trims are identical to the master. This may be checked very easily by pulling
the trainer switch. If the control surfaces move, adjust the slave transmitter
until the trainer switch can be activated without a change to the control surface
position.
Programmable Trainer Function (P.T.F.)
In this mode, the master may assign functions one at a time to make learning
to fly easier for the student. For example, the master may assign the slave
rudder and elevator only. Thus, when the trainer switch is operated, the slave
has control of rudder and elevator only, while the master retains control of
throttle and aileron. Releasing the trainer switch returns all control to the
master transmitter. Be sure to reset the slave transmitter to its defaults by
using the reset function. All servo reversing, pitch and throttle curves etc. will
be taken from the master transmitter.
Use the scroll bar to rotate around the channels and toggle between master
and slave.
Note that when all channels are set to master, the trainer system becomes
NORNAL as indicated by the “NORMAL T.” on the screen.
Timer
The timer function provides an integrated timer for each model memory and a
countdown timer too. The integrated timer shows the total time the transmitter has
been turned on for that model, and the countdown timer is useful as a low fuel
warning.
