Johnson & Johnson ASP STERRAD 100S, Installation Manual

Page: 41 / 44

Chapter 3. Installation
STERRAD
®
100S Installation Guide 41
4. Reenter the edit mode, as shown previously and change the total
machine cycles to the number you wrote down in step 4.
5. Press CANCEL and the system displays the serial number as
follows:
SERIAL NUMBER XXXXX
OPEN (change) - CLOSE (accept)
Note: The serial number is located on the frame
behind the storage drawer.
6. A flashing cursor is displayed on the serial number field. To enter the
serial number, press and hold OPEN DOOR until the desired
number is selected. Alternate between the field numbers by pressing
the
CLOSE DOOR switch.
7. Simultaneously press START and OPEN DOOR (the display
switches to the edit date/time display). Then simultaneously press
START and CANCEL to return to the active display.
Cassette Collector Box Reset
1. Remove the cassette collector box from the box base assembly.
2. Reinstall the collector box after the system has signaled reset by a
single beep tone (approximately 10 seconds).
Date and Time Reset
1. Enter the edit mode by pressing START and CANCEL at the same
time. The LCD display shows the following:
DATE = DAY, MM/DD/YY
OPEN(change) - CLOSE (accept)
2. DAY is a three letter abbreviation for the day of the week e.g.,
WED; MM is the month, e.g., 03; DD is the numerical day, e.g., 25;
and YY is the year, e.g., 95. A flashing cursor is displayed on the
DAY field.
3. To change the displayed day, press OPEN DOOR until the desired
day is selected. When the correct day is displayed, press CLOSE
DOOR to move to the month MM field.