Johnson & Johnson ASP STERRAD 100S, Installation Manual

Page: 30 / 44

Chapter 3. Installation
STERRAD
®
100S Installation Guide
30
Installing the Brackets
1. Fasten the rear bracket onto the anchor bolts using the 3/8" wide flat
washers and the nuts supplied with the anchor bolts. See the
preceding figure.
2. Remove the rubber tipped spindles on the locating pins. Then loosen
the 2 locating pins on the rear bracket. There are 4 mounting bolts on
the bracket, loosen them with a 1/2" box wrench.
3. Loosely fasten the wheel guides onto the unit.
4. If the drilling template was used, it should be completely removed,
including the tape holding it, by this point.
5. Move the sterilizer so that the subframe channels align with locating
pins on the rear seismic bracket.
6. Tighten the 4 mounting bolts on each locating pin. Tighten the wheel
guides.
7. Pull the sterilizer away from the rear locating pins. Ensure that unit
pulls out easily. The level of the floor may affect the locating pins
tightness into the channel.
8. Attach the front bracket to the anchor bolts using the 3/8" wide flat
washers and the nuts supplied with anchor bolts.
9. Adjust the rubber-tipped bumpers to stop the unit when the anchor
pins line up with the front bracket.
10. Raise or lower the anchor pin until it is at a height to fit in the front
bracket key slot.
11. With the rear panel in place, adjust the rubber-tipped spindles until
the sterilizer is stopped with the anchor pin in line with the front
bracket. Tighten the spindles.
12. Raise the anchor pin until it barely clears the bottom of the key slot.
13. Using an Allen wrench, lower the front locking mechanism to the
point where the STERRAD 100S Sterilizer is locked in place. (An
M4 Allen wrench should work.)
14. Tighten the M10 jam nut.
15. Replace the panels.