MNP37M03GBV00 Date: 24-11 Rev. 0
Page 67 of 79
11.1.7. - OP_18 Machine program version.
Press the OK Key to see the version of the program flash recorded in the control card.
11.1.8. - OP_19 Level code programming.
In this programming option you program the codes of levels 1, 2 and 3, as well as the
mode (viewing, execute and unavailable) in each of the options.
11.1.8.0 Change the level code.
Press the OK key to access the programming option. Choose the level to which you
want to change the access code. Do this with keys 1 and 2 and, when the desired level
is shown on the display, press the OK key, and the display will show the message
CHANGE CODE. If you press the OK key again, the current code will be shown for 2
seconds, and then you will be asked for a new value for the code. If you want to change
it, enter the new access code (four digits). If you do not wish to change it, press
CANCEL. To exit the option press CANCEL.
11.1.8.1 Configuration of programming options.
Press the OK key to access the programming option. Choose the level to which you
want to change the access code. Do this with keys 1 and 2 and, when the desired level
is shown on the display, press the OK key, and the display will show the message
CHANGE CODE. If you press key 1 the display will show the message PROG
ADDRESSES. If you press the OK key, you will see the existing machine programming
options and their current status for that level. If you wish to change the status of the
option, press key 3 or key 4. To move to the next programming option press the key 1,
and to go back to the previous address, press the key 2.
11.1.9. - OP_20 Fault review.
Press the OK Key for the machine to check the various machine components. It will
show the results on the display. The following components are checked:
-
Coin return motor
-
Pushbutton panel.
-
EEPROM.
-
Air break.
-
Cup dispenser.
-
Waste bin full microswitch.
-
Moving arm.
-
Cup storage.
-
Coffee assembly.
-
Coffee mill.
-
Volume counter.
-
Boiler temperature.
-
Banknote reader faults.
Should there be a fault in the coffee assembly or the coffee mill, the machine will not be
left completely out of service. Espresso coffee products will be disabled but soluble
products will still be enabled.
11.1.10. - OP_21 Resetting faults.
Press the OK Key to reset all the faults detected in option 20. The display will blink for a
few seconds while faults are reset.
