J2S Venice | J2S Rome | J2S Florence | J2S Milan | J2S Agrigento | J2S Naples | J900 | JS 32 | JS 43 | JS 49 | JS 55 | JS 65
J2S Venice | J2S Rome | J2S Florence | J2S Milan | J2S Agrigento | J2S Naples | J900 | JS 32 | JS 43 | JS 49 | JS 55 | JS 65
52
53
NFC
The NFC is always active when the totem is on. To use it, just
bring the phone, card or tag required on the totem screen,
in front of the relevant logo (see logo on the left). Contact is
usually confirmed by a “beep”. This component works only
when correctly programmed.
PRINTER
The printer is always active when the totem is turned on. It
will be put into operation directly by the totem whenever its
use is needed. The printers are available in various formats
and models, allowing the user to print sheets of different sizes.
The printer paper roll must be replaced every time it runs
out. Read the printer manual to replace the roll correctly. This
component works only when correctly programmed. Check
the maximum diameter of the paper roll that can be inserted
in the purchased totem (ex. J2S Agrigento Ø160 mm).
QR CODE & BARCODE READER
The QR Code & barcode reader is always active when the
totem is on. To use it, simply bring the barcode or QR code
requested on the totem screen to the reader. Contact is
usually confirmed on the screen. This component works only
when correctly programmed.
GEL DISPENSER
The gel dispenser is always active even when the electronics
of The gel dispenser is always active even when the totem
electronics are off. To use it, just bring one or two hands close
to the dispenser in the compartment and indicated by the
label you see on the left.
The nozzle will deliver 1 ml of sanitizing gel that must be
used to disinfect hands. The gel will evaporate in seconds.
In addition to sanitizing, J-Gel moisturizes the hands with
vitamins and essential oils, leaving them scented.
Check if the gel is compliant and make sure it does not
contain allergens.
Summary of Contents for ITJ932P100-3Y
Page 32: ...62 ...
