J2S Venice | J2S Rome | J2S Florence | J2S Milan | J2S Agrigento |
J2S Naples
|
J900
|
JS 32
|
JS 43
|
JS 49
|
JS 55
|
JS 65
J2S Venice
|
J2S Rome
|
J2S Florence
| J2S Milan | J2S Agrigento | J2S Naples | J900 | JS 32 | JS 43 | JS 49 | JS 55 | JS 65
46
47
CHANGE IN DURATION OF DISBURSEMENT
During normal operation, it is possible to change the dispensing duration.
1. To access this function, the sensor
(5.2)
must be blinded for about 60
seconds. Continuing with the blinding, the RED indicator light inside the sensor
(5.2)
starts flashing for a maximum number of 6 times.
2. By removing your hand at the desired flash (from 1 to 6) the relative delivery
will be set.
Delivery is proportional to the number of flashes. The greater the number of
flashes selected, the longer the dispensing time.
At this point the RED indicator light inside the sensor
(5.2)
will light up for 3
seconds following with the same number of flashes chosen for verification.
3. Now you can use the article with the selected setting. If the hand is not
removed during the selection process, no signal will be given, much less the
previously set dispensing value will be changed.
5.5.1 ELECTRICAL ACTIVATION AND NETWORK CONNECTION
To proceed with the electrical and network activation of the totem, follow the
steps below:
1. Insert the power supply cable
(8.2.A)
into the power switch
(8.1.A
).
2. Insert the Schuko plug of the power supply cable
(8.2.A)
into a 220V socket.
3. Insert the LAN cable
(9.2)
into the LAN socket
(9.1)
.
4. Insert the second end of the LAN cable
(9.2)
into a network port available to
you.
5. Activate the power switch
(8.1.A)
by pressing the button on
symbol
I
.
6. The totem will turn on automatically, ready for configuration.
Summary of Contents for ITJ932P100-3Y
Page 32: ...62 ...
