SECTION 2 - PREPARATION AND INSPECTION
3121783
2-5
Walk-Around Inspection
General
Begin the "Walk-Around Inspection" at Item 1, as noted
on the diagram. Continue checking each item in
sequence for the conditions listed in the following
checklist.
TO AVOID POSSIBLE INJURY, BE SURE MACHINE POWER IS OFF.
DO NOT OPERATE MACHINE UNTIL ALL MALFUNCTIONS HAVE BEEN COR-
RECTED.
INSPECTION NOTE
: On all components, make sure there
are no loose or missing parts, that they are securely fas-
tened, and no visible damage, leaks or excessive wear
exists in addition to any other criteria mentioned.
1. Platform Assembly, Foot Switch, Ladder
and
Gate
- Foot switch in good working order, not
modified, disabled or blocked. Manual(s) in stor-
age container, access bar slides up and down prop-
erly, platform properly installed and with both
caps screwed on. See Inspection Note.
2. Control Stations
- Switches and buttons return to
neutral, decals/placards secure and legible, control
markings legible.
3. Outriggers
- See Inspection Note; pads pivot
freely.
4. Electrical & Hydraulic Cover Assemblies
- See
Inspection Note.
5. Boom Sections & Turntable
- See Inspection
Note.
6. Drive Tracks
- Properly Adjusted. See Inspection
Note.
7. Diesel Engine or Lithium ION Battery Pack
- Free
of debris and See Inspection Note.
8. Swing Drive & Turntable Bearing
- Check for
proper lubrication. See Inspection Note.
9. Hydraulic Tank
- Hydraulic oil level correct and
See Inspection Note.
10. Electric Engine and Hydraulic Pump
- See
Inspection Note.
11. Platform Rotator & Machine Bubble Level
- See
Inspection Note.
To
order
go
to
Discount-Equipment.com
