JLG 1850SJ, Service And Maintenance Manual, Page: 400 / 712

SECTION 5 - BASIC HYDRAULIC INFORMATION & HYDRAULIC SCHEMATICS
5-148 3121619
Figure 5-140. Control Cutoff Valve
Table 5-41. Fastener Size and Torque Chart
Item Fastener Wrench size Torque
D015 Neutral adjust screw 4 mm internal hex NA
D050 Control coil mounting screw 4 mm internal hex 8 Nm [5.9 lbft]
D060 Neutral adjust locking nut 13 mm hex 10 Nm [7 lbft]
D200 Swash plate feedback pin (not shown) 13 mm hex 25 Nm [18.4 lbft]
D250 Electric control mounting screw 5 mm internal hex 13 Nm [9.5 lbft]
E350 Servo cylinder locking screw 10 mm hex 14.5 Nm [11 lbft]
G10 Control cutoff valve 1 1/16 in hex 45 Nm [33 lbft]
G10B Control cutoff valve coil nut 24 mm hex 9 Nm [7 lbft]
K007 Charge check / HPRV 8 mm internal hex 80 Nm [60 lbft]
K350 A pad cover mounting screw 17 mm hex 70 Nm [52 lbft]
B pad cover mounting screw 8 mm hex 111 Nm [82 lbft]
V10-1 Charge relief valve 27 mm hex 52 Nm [38 lbft]
V10-2 Charge relief valve 1 in hex 52 Nm [38 lbft]
Table 5-42. Plug Size and Torque Chart
Item O-ring plug Wrench size Torque
B015 7/16 - 20 3/16 internal hex 20 Nm [15 lbft]
B020 1-1/16 - 12 9/16 internal hex 48 Nm [35 lbft]
D065 7/16 - 20 3/16 internal hex 12 Nm [9 lbft]
G250 9/16 - 18 1/4 internal hex (hardened plug) 45 Nm [33 lbft]