PAGE 14 of 47
4.6. Vertical Probe Holder
A
Latch
B
Probe Holder Adjustment Knob
C
Vertical Adjustment Knob
D
Pivot Buttons
E
Probe Holder Arms
F
Yoke
G
Probe Holder Arm Adjustment Knob
H
Transverse Adjustment Screw
I
Frame Bar
4.6.1. Probe Holder Setup
1.
The probe holder adjustment knob allows the probe holder to be attached
to a frame bar, as well as horizontal positioning on a frame bar
(Fig. 43)
.
2.
The vertical adjustment knob allows the vertical probe holder height
adjustment
(Fig. 44)
.
3.
Position the pivot buttons where necessary. When a narrow scanning
footprint is required, use the pivot button holes closet to the yoke
(Fig. 45)
.
TIP:
Probe pivoting may be impeded when closer to the yoke.
D
E
H
F
G
B
C
I
A
Fig. 42
- Vertical probe holder
Fig. 43
- Adjust on frame bar
Fig. 44
- Vertical adjustment
Fig. 45
- Place buttons
