PAGE 9 of 47
BG0104 Rev 03.3
4.4.2. Wheel Block with Handle Mounting
To mount a wheel block with handle, follow these steps:
1.
Loosen the wheel block with
handle wing knob
(Fig. 23)
2.
Slide the wheel block with handle
onto the dovetail of the dual pivot
frame bar
(Fig. 24)
.
3.
Tighten the wheel block with
handle wing knob
(Fig. 25)
.
4.4.3. Wheel Block with Handle Positioning
Adjustment of the wheel block with
handle position on the dual pivot
frame bar will be necessary on smaller
diameter circumferential scan surfaces.
TIP:
Positioning of wheel block with
handle is only required when the
longitudinal scan diameter is less
than 30.5 cm (12 in).
1.
Release the dual pivot frame bar
ratchet levers
(Fig. 16)
.
Fig. 23
- Loosen wing knob
Fig. 24
- Attach to a frame bar
Fig. 25
- Tighten wing knob
Fig. 26
- Simple wheel block positioning
