PAGE 19 of 47
BG0104 Rev 03.3
6.
Mount the yoke to the opposite side of the base using the supplied 3 mm
hex driver
(Fig. 63)
.
TIP:
Keep the yoke level with the base as to ensure no conflicts with the
plunger/set screw attached to the yoke.
7.
Locate the recessed M3 screw on the bottom of the probe holder. Unscrew
the stop post using a 1.5 mm hex wrench until it has cleared all obstructions.
Do not remove stop post
(Fig. 64)
.
8.
Raise the stop post on the opposite side until the side of the post clearly
contacts the 90° stop point on the probe holder’s base
(Fig. 65)
.
Fig. 63
- Screw yoke to opposite side
Fig. 64
- Lower 90° stop post
Fig. 65
- Raise opposite 90° stop post
Fig. 66
- Reversed probe holder
