(12) Using Remover C-4210 and Handle C-4171,
drive input shaft bearing into case. The bearing
locating ring must be fully seated against case sur-
face.
(13) Remove input gear pilot bearing by inserting
a suitably sized drift into the splined end of the input
gear and driving the bearing out with the drift and a
hammer (Fig. 221).
(14) Install new pilot bearing with Installer 8128
and Handle C-4171 (Fig. 222).
INPUT AND LOW RANGE GEAR
(1) Lubricate gears and thrust washers (Fig. 223)
with transfer case lubricant.
(2) Install first thrust washer in low range gear
(Fig. 223). Be sure washer tabs are properly aligned
in gear notches.
(3) Install input gear in low range gear. Be sure
input gear is fully seated.
(4) Install remaining thrust washer in low range
gear and on top of input gear. Be sure washer tabs
are properly aligned in gear notches.
(5) Install retainer on input gear and install snap-
ring.
(6) Align and install low range/input gear assem-
bly in front case (Fig. 224). Be sure low range gear
pinions are engaged in annulus gear and that input
gear shaft is fully seated in front bearing.
(7) Install snap-ring to hold input/low range gear
into front bearing.
(8) Install a new input shaft seal with Installer
C-3995-A and Universal Handle C-4171.
Fig. 220 Input Shaft Bearing Removal
1 - SPECIAL TOOL C-4171
2 - SPECIAL TOOL C-4210
Fig. 221 Remove Input Gear Pilot Bearing
1 - DRIFT
2 - INPUT GEAR
Fig. 222 Install Input Gear Pilot Bearing
1 - HANDLE C-4171
2 - INSTALLER 8128
3 - INPUT GEAR
21a - 130
TRANSMISSION AND TRANSFER CASE
WG
TRANSFER CASE - NV247 (Continued)