ASSEMBLY
(1) Install piston (6) (Fig. 51) in the outer multi-
ple-disc carrier (1). Check sealing rings (4 and 5),
replace if necessary. The rounded off edges of the
sealing rings must point outwards.
(2) Insert disc spring (7) (Fig. 51). Insert disc
spring with the curvature towards the piston.
(3) Insert spring plate (8). Insert spring plate with
the curvature towards the sun gear. Check sealing
ring (9), replace if necessary.
(4) Place Multi-use Spring Compressor 8900 on
spring plate (8) and compress the spring until the
groove of the snap-ring is exposed.
(5) Insert snap-ring (10) (Fig. 51). After installing,
check snap-ring for correct seat
NOTE: Pay attention to sequence of discs. Place
new friction multiple-discs in ATF fluid for one hour
before installing.
(6) Insert multiple-disc pack (12) in the outer mul-
tiple-disc carrier.
(7) Insert snap-ring (11).
Fig. 51 Driving Clutch K1 Components
1 - K1 OUTER DISC CARRIER
7 - DISC SPRING
2 - FREEWHEELING CLUTCH F1
8 - SPRING PLATE
3 - SNAP-RING
9 - SPRING PLATE SEALING RING
4 - OUTER DISC CARRIER SEALING RING
10 - SNAP-RING
5 - PISTON SEALING RING
11 - SNAP-RING
6 - PISTON
12 - MULTIPLE DISC PACK
21a - 50
TRANSMISSION AND TRANSFER CASE
WG
DRIVING CLUTCH K1 (Continued)