(12) Using grease, insert Teflon rings (7) (Fig. 37)
in the groove so that the joint remains together
(13) Mount clutch K1 (1) (Fig. 37).
(14) Install drive shaft with clutch K2 (6) and
front gear set (1) (Fig. 37).
(15) Install front washer (5) and thrust needle
bearing (4) (Fig. 37).
(16) Install output shaft with center and rear gear
set and clutch K3 (3) (Fig. 37).
(17) Using grease, install both Teflon rings in the
groove at the rear of the output shaft so that the
joint stays together.
(18) Mount transmission housing on converter
housing.
(19) Screw in Torx socket bolts through the trans-
mission housing into the converter housing. Tighten
the bolts to 20 N·m.
(20) Measure end play between park pawl gear
and grooved ball bearing.
(a) Place Parallel Rest 8906 (1) on transmission
housing. Using the depth gauge, measure from the
parallel rest (1) to the parking lock gear (2) (Fig.
38).
Fig. 35 Install Holding Clutch B1 and Oil Pump
1 - BOLTS - M6X32
4 - BOLTS - M8X35
2 - CONVERTER HOUSING
5 - HOLDING CLUTCH B1
3 - INTERMEDIATE PLATE
6 - OIL PUMP
Fig. 36 Install New Oil Pump Seals
1 - INNER OIL SEAL
2 - OUTER OIL SEAL
21a - 36
TRANSMISSION AND TRANSFER CASE
WG
AUTOMATIC TRANSMISSION - W5J400 (Continued)