Chapter 6 Multiple Streams Testing
Enabling streams and specifying the traffic load
HST-3000 Ethernet Testing User’s Guide
183
b If you selected a layer 3 or layer 4 test, indicate
whether you want to specify a packet or frame length
when you configure IP or TCP/UDP traffic by selecting
Packet Length or Frame Length.
c If you selected a layer 3 test, and you intend to
transmit MPLS encapsulated traffic in every enabled
stream, set MPLS Mode to Enabled; otherwise, select
Disabled.
If you enable MPLS Mode, you can specify the MPLS
EtherType and MPLS labels for each stream on the
EthConfig per Stream configuration menu (see
uring traffic streams” on page 187
).
The test is selected.
Enabling streams and specifying the traffic load
Before transmitting multiple traffic streams, you must specify
the traffic characteristics that will apply to all enabled streams,
enable each individual stream you intend to transmit, and
configure the traffic load for the streams.
To enable traffic streams
1 If you haven’t already done so, launch the IPv4 Multiple
Stream Terminate application for the circuit you are
testing (see
“Launching an application” on page 28
), and
).
2 Press the Configure navigation key.
A configuration menu appears.
Summary of Contents for IP Video Test Option HST-3000
